You must have javascript enabled to use universal-remote.org !

Universal Keystone Wall plate Mount IR Receiver Dual Frequency HDTV IR

Repeaters

USD $10.00

Condition : New

Free Shipping

{{variant_type_name}} :
eBay
SKU: Keystone Dual freqency IR Receiver This site contains affiliate links for which we may be compensated Consumer Electronics / TV, Video & Home Audio / TV, Video & Audio Accessories / Remote Controls

Notify me when the price drops

We will email you if we find a lower price on this product!

Target price (USD) $
Don't confuse our Keystone with the basic Single Frequency IR receivers sold by others.
If you have the newer HDTV DVR's, Cable and Satellite boxes many of them use a higher frequency than what has normally been found in homes in the past.
This is why ours are Dual Frequency / Dual Band.

Features:
  • Dual Frequency for Today's HDTV Products
  • CFL Friendly, allows installations in areas with compact fluorescent lighting, and works in most lighting environments.
  • IR confirmation LED provides user feedback when IR signals are sensed

It's simple to Install:
  • Mount the Keystone IR Receiver in any standard Keystone Wall Plate.
  • Run Cat5 cable from the receiver to the IR Block connecting block. (2 twisted pairs required, shielded or unshielded).
  • Then all you have to do is aim your remote control at this IR Receiver, which will automatically send the signal through to your devices!
  • IR confirmation LED provides user feedback when IR signals are sensed
Specification:
  • Receive frequency range - 34 KHz to 60 KHz
  • Transmit frequencies - 38 KHz & 56 KHz
  • Range - 40ft. @ 38 KHz - 25ft. @ 56 KHz
  • Power - 12VDC, 30mA max.
  • Dimensions - 39.5L x 19.3W x 24H mm
  • Connector type - Spring Clamp Terminal Block
  • Wire range - 20-26 AWG
Special Note: These are designed to work with the IR repeaters systems that we sell. We cannot warrant or guarantee they will work with any other system so please do not try this as it could damage your system or this device.


Installation Notes and Hints -
  • Strip back approximately ½" of the conductor on TWO of the pairs. Match the connection markings from the In Wall Infrared receiver wall plate to the connecting block of the advanced IR receiver.
  • Installation Note -
  • Most States require that when running cable inside walls, you must use fire rated cable such as CL-2 or CL-3.
  • To avoid possible noise interference from induction from 115 VAC, never run low voltage and AC lines together.
  • Installation Hint -For best appearances, mount the device at the same height as installed light switches.
  • Room Placement:Place IR Wall Plate in direct "Line-of-Site" of the hand held remote control up to 25’ away and within a 120° of the device.

Universal Keystone Wall plate Mount IR Receiver Dual Frequency HDTV IR Repeaters
universal remote ceiling fan | universal remote with pointer | universal remote for sony receiver | sony universal remote | uei universal remote codes
See more
Price type
IN STOCK OUT STOCK