STOCK 885A 1 Provision/
Martin/Marantec 2-button Garage Door Opener Remote Model M3-2312 tested
guarantee work.Sale is for one remote from the picture only.Used like
new.tested has great signal.Please see pictures for conditions . the
pictures item is actual item you will receive. New installed battery is
included.Will ship fast after received payment Thank you!
M3-2312
(Alternate Spelling: M32312 )Compatible remote controls: M3-2312,
M3-2314 and keypad model M13-631 Replaces discontinued remote control:
ML-1312V Operates 2 Marantec 315MHz garage door openers or gates
Battery Type
1; CR2032
Frequency
315 MHz
Buttons
2: Led Light
Compatible Vehicles FOR THIS FCC ID / PART #
Compatible with 315MHz Openers:
M-4500, M-4700, Q7500, Q-7700, Q-7900, M-LINE, Q-LINE
Works with openers M-4500e, M-4700e, M4900e, M7500e, RV8000, and LC1000
Works with openers M50, M55, M4500eco, M4700eco, Synergy 270, Synergy 370, Synergy 380
Programming Instructions:
1. Using the Transmitter
All transmitters come with batteries already installed.
- To open or close garage door, press and hold the button (Mini
and Micro transmitters have indicator lights). When garage
door begins to move release button.
- To stop the garage door during travel, press and hold button
until door stops, then release button.
- To continue the garage door travel after stopping it, press and
hold the button. Press button once, the door will travel in the
opposite direction
2. Battery Replacement
Open the transmitter by using small coin.
The installation of the battery for
Mini and Micro is the same.
When replacing batteries follow the steps below:
Close the transmitter.
Note: Replace batteries with same type only
.Insert a 3V battery (type CR2032)
3. Multiple Transmitters
Each transmitter comes factory programmed with random
codes. 2-channel transmitters have 2 different random codes,
one per button, 3-channel transmitters have 3 different random
codes and 4-channel transmitters have 4 different random
codes, one per button. Transmitters that are purchased
separately as accessories have random codes that must be
changed in order to match the code of the "active" transmitter,
which you are already using. Below are instructions for
transferring an active code from a button on one transmitter to a
button of your choice on another transmitter.
Connect the transmitter with active code to the new
transmitter using the programming connector (fig. 3A).
Press and hold the selected channel button on the transmitter
with the active code. The light in the transmitter
illuminates.
Press and hold the respective channel button on the new
transmitter. The light in the transmitter initially starts
blinking and then illuminates continuously after 1-2 sec. Code
transfer is completed.
Programming connector can be removed and both transmitters can now be used to
operate the same door.
Note: For multi-button transmitters, be sure to carry out this
procedure for all the buttons you desire to use.
4. Changing the Code on Transmitters
The transmitter factory preset code can be changes as follows:
Connect the programming connector into the lateral socket of
the transmitter to change the code.
Short one of the outer pins of the programming connector with
the middle pin.
Press and hold the respective channel button. The light will blink
rapidly for approx. 5 sec. Release the button after the light
illuminates continuously. Then remove the programming
connector.
Note: For multi-button transmitters, be sure to carry out this
procedure for all the buttons you desire to use.
Returns Accepted for this item if it's within 30 Days